Turnigy Accucell 6 Balance Charger : Not Entering in Calibration Mode

<< < (2/2)

Mjet:
I was purchased this charger from Hobbyking. I informed and sent a video of process to HK and they credited amount in my account as warranty settlement.

I still has this charger, working fine, only I add the .25 volts in reading of charger. You can also find the + or - ve difference and read the readings.

rastsaurabh:
fine, but how do you put batteries into storage voltage?

Power_user_EX:
Quote from: Mjet on August 01, 2012, 01:41:20 PM

Hi All,

I had purchased a new Turnigy Accucel 6 balance battery charger from Hobby King. Charges is working fine but not entering in Calibration mode.

Voltage shown by the charger is lower (.25 V) as compared to  measured by multi meter  :banghead:.

Looking forward to senior members for help in this regard  :help:.

Thanks and Regards
Mohan



Which multimeter are you using to check the voltage ? You cannot trust the cheap chinese multimeters for this.

Quote from: rastsaurabh on October 12, 2015, 10:00:52 AM

fine, but how do you put batteries into storage voltage?

On Accucell 6 or similar there is LiPo Storage setting, similar to lipo charge. It will automatically bring your battery to storage voltage(by either charging or discharging) which is around 3.8V per cell for LiPo/LiIon.

I would suggest flashing this firmware : https://github.com/stawel/cheali-charger which gives some extra features. First make sure you model uses atmega32 or M0517LBN MCU.

Navigation

[0] Message Index

[*] Previous page