Turnigy Accucell 6 Balance Charger : Not Entering in Calibration Mode

(1/1)

Mjet:
Tweet


Hi All,

I had purchased a new Turnigy Accucel 6 balance battery charger from Hobby King. Charges is working fine but not entering in Calibration mode.

Voltage shown by the charger is lower (.25 V) as compared to  measured by multi meter  :banghead:.

Looking forward to senior members for help in this regard  :help:.

Thanks and Regards
Mohan

Sandeeppande:
Hi Mohan,

can you describe the process you are following to bring it under calibration mode?

this process is common for MOST of 4 button chargers as most of them follow the same binary and almost same set of microcontrollers.

Thanks,
Sandeep

Mjet:
Thanks for reply.

As I Learnt from various videos available at you tube, pressing and holding the "Start" and “ Dec” button and power on.

Sandeeppande:
Looks you are following the process right.

Press start ( keep it pressed) then press decrease/status (keep this also pressed), turn on power, this should enter into calibration mode.

this is the standard process, mostly, we just miss keeping the buttons pressed (these get released), just watch this closely and you should be able to bring it under calibration mode.

Thanks

Navigation

[0] Message Index