Hello guys I'm a beginner, I had built a biplane recently and crashed it
, however I have built a Delta wing from Thermocol and its my second build but there are certain challenges which I am facing right now and I hope people here can help get flying ASAP.
Note : I have the required material to get it flying but I feel the battery is a bit heavy and theres a problem with the CG in my models.I will post pics of the construction
Right now I have the following
1) RcB6i Tx & Rx - 6 channel
2) CF2822 motor - 1200KV
3) 30 amp ESC
4) 9g servo
5) 2200 mah 25 C LIPO
a) I need to know which of the above I can use in this Delta Wing.
b) also what propeller should I use and how do I mount the propeller..?
c) Should I mount it the Opposite way or mount it the normal way and reverse the motor direction?
if not then what others should I use
The dimension of the delta wing are as follows
Width : 37 inches
height : 18 inches
Now the Build Log1) First I cut thermocol with the help of paper printouts
Delta Wing Construction - Help Needed
2) The cutout
Delta Wing Construction - Help Needed
3) Next I cut out wing Shapes with a blade and used sand paper to get a nice finishing - I want to use this for the flaps
Delta Wing Construction - Help Needed
4) Next I cut out strips to cover the back of the delta wing where the motor is mounted and pasted them (I dont know what its called)
Delta Wing Construction - Help Needed
Delta Wing Construction - Help Needed
5) Next I wanted it to look nice when its Flying so went to one of my friend to get it painted..
Delta Wing Construction - Help Needed
Delta Wing Construction - Help Needed
Delta Wing Construction - Help Needed