|
Title: Multiwii se v2.5 not showing pitch & yew signal Post by: atul_at2112 on November 14, 2016, 01:48:18 PM Hey gyz I m working on multiwii se 2.5 board m done with reciver connections but unable to arm the board so I used multiwii conf program that shows orientation n readings of each sensor (gui) in that I observed board is not showing pitch n yew reading at all although it's giving throttle n roll reading I checked program I have selected quadx configuration rytly n I checked recover also it's giving signal in all 4 channels but multiwii is not getting those two signal plz help me on this this is my project n nw m stuck with it plz reply if u knw help me....
|