|
Title: Need help with Sky Surfer power setup Post by: gunnu on August 20, 2014, 01:02:43 AM can any one help me.?
i order sky surfer1400 mm. and one 7x5E APC STYLE COMPOSITE PROPELLER. can i use this with my sky surfer default motor and ESC: 20A .(i dont know which motor includes in kit.). and i also want suggestion. where should i put esc. inside the plane or outside the plane. for better cooling. or to cut out duct on plane for air flow inside the plane.. help. Title: Re: Need help with Sky Surfer power setup Post by: Rcjabalpur on August 20, 2014, 01:17:41 AM Gunnu ,
Get a watt meter connect your ESC and MOTOR to it and give it full throttle see how much amp the motor is drawing for example If a motor a is drawing 18 Amp and the ESC is rated at 20 Amp the esc will get hot , but if you go for a 30 Amp ESC it would barely get warm . But then again you can put the esc out for better cooling if you dont want to do this Title: Re: Need help with Sky Surfer power setup Post by: devangflyer on August 20, 2014, 01:33:33 AM :iagree: But , if you don't want purchase a watt meter , just buy the stock propeller from here - http://rcbazaar.com/products/1539-skysurfer-v3-prop.aspx (http://rcbazaar.com/products/1539-skysurfer-v3-prop.aspx) and it should work great with stock motor , because the stock propeller is 6 inch , and yours is 7 inch
Title: Re: Need help with Sky Surfer power setup Post by: manojswizera on August 20, 2014, 11:16:05 AM 7 inch prop will not fit, you have to cut some foam out.
Title: Re: Need help with Sky Surfer power setup Post by: Rcjabalpur on August 20, 2014, 03:17:25 PM Devangflyer , but dont you think an electric flyer should have that meter its always good to know about the stats
In the longer run it will also help him to choose between different props |