RC India
Welcome Guest, please login or register.
 
Pages: [1]   Go Down
0 Members and 1 Guest are viewing this topic. Topic Tools Topic Tools 
Read
« on: December 05, 2018, 02:32:43 PM »
veera
Car Lover
Active Member
**

Reputation Power: 1 
veera has no influence.
Offline Offline

City: coimbatore
State: Tamil Nadu
RC Skills: Beginner
Posts: 4
Join Date: Jul, 2014




Hello all.... I have an eachine 250 pro with F3 board...the issue i face is the drone is not flying after 3 or 4 flights after the bootloader works are done and saved those in F3 board ....i am using a cleanflight v 1.2.4 which i did after watching some youtube videos ....please help me in this....some time one of the motors is not running ...sometimes all four working good....!
Logged
 

Read
« Reply #1 on: December 05, 2018, 08:57:40 PM »
newpg202
Plane Lover
Active Member
**

Reputation Power: 1 
newpg202 has no influence.
Offline Offline

City: NORTH 24 PARGANAS
State: West Bengal
RC Skills: Intermediate
Posts: 35
Join Date: Oct, 2018



Calibration of ESC is needed perhaps.

Sent from my Mi A1 using Tapatalk
Logged
 

Read
« Reply #2 on: December 06, 2018, 09:44:25 PM »
veera
Car Lover
Active Member
**

Reputation Power: 1 
veera has no influence.
Offline Offline

City: coimbatore
State: Tamil Nadu
RC Skills: Beginner
Posts: 4
Join Date: Jul, 2014



How to do that???now the problem is my drone is not responding my commands☹️
Logged
 

Read
« Reply #3 on: December 06, 2018, 11:25:43 PM »
sim_tcr
Car Lover
Senior Member

***

Reputation Power: 3 
sim_tcr has no influence.
Online Online

City: Thrissur
State: Kerala
RC Skills: Beginner
Posts: 176
Join Date: Jan, 2018



How to do that???now the problem is my drone is not responding my commands☹️
Connect the FC to computer, keep the battery disconnected.,
In configurator go to Motors tab
Enable, I understand the risk,
Move the master slider to maximum position and connect the battery. Once the beeps are completed, lower master to zero and ESCs will finish their tones.
Disconnect the battery and connect again. Raise Master very slowly until the motors are spinning comfortably. Make a note of the value this is at.
In Configuration tab,change Min Throttle to about 20 points greater than the value you noted earlier.
Hit Save and Reboot.
Logged
 

Pages: [1]   Go Up
Jump to:  

Related Topics
Subject Started by Replies Views Last post
Another newbie here..
Multirotors
hypd09 3 1578 Last post November 13, 2012, 12:34:02 AM
by anand21nanda
X3 Newbie
Helis
Cary101 6 2529 Last post December 05, 2012, 03:55:37 PM
by raja_mastana
Need help for a newbie
Beginners Zone
v2 eagle 4 3024 Last post August 04, 2013, 09:10:24 AM
by rcrcnitesh
I'm a newbie,So please help me!!!
Beginners Zone
Aravind298 9 3536 Last post April 27, 2016, 03:25:37 PM
by SI74
Newbie
Tools, Materials and Building Techniques
Wassiriour1942 1 1081 Last post May 12, 2016, 01:45:22 PM
by prabal276