* Building material (
depron or thermocol or epp or epo or coroplast) Most of these are not available (Check out
http://www.kinetichobbies.com/) , (RCDhamaka.com), (RCBazaar.com)
* Building plans (Start from easy first. Search for trainer models like blue baby or Sky King) (A high wing slow aircraft should be ur preference as it will give you ample of response time)
********Electronics*********
* 1
Brushless motor and a
prop (It could be a pusher or a puller) (RS 500+)
*
Esc for motor. It should be atleast 5-10 amps more than the need of the motor (RS 500+)
*
2 or 3 Servos To control control-surfaces(Ailerons/rolling, elevators/pitch/Going-up-down and rudder) (Rs 170+ per motor)
* lipo battery and charger. Be carefull with the battery (depends on the weight of aircraft and power required because high capacity will be higher in weight. and carrying higher weight will be inefficient So it wont increase ur flying time too high)
*
Transmitter and a receiver(atleast 6 channels) (Most important) (Starts from RS-2850/- Flysky CT6B) But as per forum people go for Futaba Or JR(expensive ones)
*******hardware**********
* Cutting knives and blades (rs 160+)
*
HOT GLUE (400rs for hot glue gun and rs 10 to rs 15 for hot glue sticks)
*
Packing tape(Give a coating to ur aircraft using this for extra strength) rs 85 to 500 rs
* Push rods to connect servo motors and control surfaces using CONTROL HORNS(rs 35 to 70 for 5-6 push rods and rs 25+ for control horn per peice)
Lots of patience
And knowledge and passion. Start watching Flitetest videos Beginner Series. And "Maker Hangar" on youtube
And also search for
CG ie Center of gravity(Dont know much about how to calculate this. even i am doing R and D on it)
Sometimes you will need to solder a few things. So get a
soldering setup as well
You may need to be careful about the
connectorsHope these points will help.
(And pls do R and D on above points to get better picture of what i am saying)