sirjee one silly question, is there any LHS where such kits is available..? I am working on my quad right now, my next aim will be either a boat or a simple RC plane.

Talking about planes sirjee do you have a tuts for RC plane as well??

Thank you roopeshji for all that details about putty.   

carry on Swiz..
Satya, please contact VC Sir for the kits of this boat.. 

Once again Roopesh Sirji

        

T H A N K S 

for the Build Guide Line

        

thank you.. and carry on..

Roopesh Sir, thanks a lot for this post.......super timing.....I am going to apply the putty stuffs to my boat now.
Thanks for all the inspirations and information.     

Regards
Pirate

Wonderful Roopesh sir. Expecting video.

 

thank you all Respected members..sure, will upload a video sequence..

roopesh sirji

will EMAX-CF2805 with turnigy 10amp esc work ?

HXT 900 for radar

sure a theoratically 10 Amps ESC will work nicely with a 80 to 95 Watt motor,at 1600 RPM,  in 7.2 volts, with a 1 inch hand made prop, with shallow angle..
and a best option is a 1000 RPM motor, with a 120 Watt, and a prop in 1 inch dia, with moderate angle will work perfectly.. and in 11.1 volts or in 12 volts, we need only a little throttle to fly this boat over water.. about half throttle the boat will hydroplane literally.. so, a best combination is a 1000 RPM/ 120 Watt motor, a 30 Amps ESC, witha 11.1 Volt LiPoly.. and this will also give you all a very long running time at low speeds..

and we can use any micro servos to drive any radar dishes on our craft.. i already posted an article about rotating servo, that shows you all how to convert an ordinary servo in to a rotating servo..

here can see the motor set up.. is a 1000 RPM motor along with a 30 Amps ESC..

motor coupling.. is simple..