Picked up this balsa kit some where in mid feb I suppose from www.rcbazaar.com

Wonderfull kit. Neatly cut and build by numbers with  plan.

The kit was basically meant for rubber powered. However planning to make it electric and RC controlled. kit has no provision for control surfaces. Some modification would be needed to make it RC. Worst case at least should be able to provide ruder and elevator.

Till now the rudder and tail plane and structure of fuse is ready. Wing and covering for fuse is balance.

This is made electric and with 3 Channel and flying very nicely. Last sunday we managed to bend the shaft of the motor. Once replaced the shaft it will be made air worthy and flight videos are due.

Sir looks beautiful, Love to see this in action..

Wow

Superb! These Guillows are fabulous. Brilliant building and adaption sir 

Very Good built. what is the Power setup ?
2S with 20 watt motor (4025) or 30 watt (5030) ?
with 3.7 gm servo ?
Airframe, electronics and AUW please for us.

Thank you Kalyan Da, Arun and Sanjay Sir,

The Motor is http://www.hobbyking.com/hobbyking/store/__6312__hexTronik_5gram_Brushless_Outrunner_2000kv.html



The ESC is Hobby King 6 Amps ESC

http://www.hobbyking.com/hobbyking/store/__21246__HobbyKing_6A_ESC_0_5A_UBEC.html



2 x 3 Gms Servos

Propeller GWS EP 4530

Receiver Futaba 6004 Micro four Channel Receiver.



2S 400mah Lipo