Well when I first saw this little marvel in PankajC's build thread, I never thought I would ever build this! So, here it is. Sorry my camera was on loan so I could no take picture of the initial stages.
Original Plan : Tony65x55 on Rcgroups
Original Build Thread :
http://www.rcgroups.com/forums/showthread.php?t=681556&page=1Plan PDFs :
http://www.rcgroups.com/forums/showatt.php?attachmentid=1846489&d=1209747379 http://www.rcgroups.com/forums/showatt.php?attachmentid=1846490&d=1209747379 http://www.rcgroups.com/forums/showatt.php?attachmentid=1846488&d=1209747379Material : 4mm Biofoam
WS : 24"
Aerofoil : 4-40 under chambered (Heat molded)
AUW : 220g
Motor: TURNIGY 2204-14T : 1450 kv/19g/2-3s
http://www.hobbycity.com/hobbycity/store/uh_viewItem.asp?idproduct=6547 Prop : GWS 8x4.5 SF
ESC : Exceed RC 12A
LiPo : Flightmax/Rhino 2S/500mAh/20c
Servo : 2x HXT500 for Rudder and elevator
1x HXT900 for Ailerons
in this post, I am attaching the pictures after completion and straight back to stage where Fuse/Mono block were pasted and Servos were fixed.
Note that due to space constraints in the Fuse, I had this unique placement of Servos where the servos elevator/rudder where first pasted together back to back, each's arm over others base. This saved me from having a bend in the push rod for clearance as the 1mm spring wire I used for rods would have flexed due to the bend.
Below:
Pic1: The completed Babe
Pic2: Servos stacked back to back, each one's arm over other's base
Pic3: Push rods exit at rear. Due to wrong build sequence, I ended up cuttign and then reinforcing fuse to insert the push rods