Hi Augustinev/flyboxer,
finally I've started building the YAK 54 bought from Pravin.
Presently received the below consigment from HKB (after 25 days)
TR 35-36B 1300kv Brushless Outrunner (Eq:2814)
BATTERY Turnigy 2200mAh 3S 30C Lipo Pack
TURNIGY TRUST 45A SBEC Brushless Speed Contr
APC style propeller 10x5-E
HXT900 9g / 1.6kg / .12sec Micro Servo -Still waiting for next consigment to come from HK along with batt .charger (consgment to arrive next or so).
Presently ,I don't have an 9in 9 inch extension lines for rudder & stab,used 4 extension line ,& also no y connector for alerons but need these ,will check whether rc damaka has it ?
1) To start with : completed all servoes attachment drilling of small holes & fixing of 2 servoes.
(borrowed by my friend)
"
Servo mount for elevator and rudder requires reinforcement, used CA and Soda (A little) " can you explain how was this done ?
2) Glued the elevator & rudder.with respect the wing tip to elevator with equal distance & also check that the wing & stab are parallel to each other.
3) Wing joiner pipe (Surprise was 1mm lose was falling out of fuselage if tilted side ways,put a tape on it so it stays firm on both wings & the fuselage.
4) for engine mount ,wanted to mount the motor in front of the mount & not inside as I want to use the thread accessories shaft provided by the mfg ,if I mount the motor inside the mount then I have to use the thin shaft,what the correct way,new to electric.
" PLEASE mount motor onto the mount plate before you make the mount (Do not follow the book)".5) Thanks to your son scale ,for the idea of installing battery is just great.Also the rubber trick for landing gears is well noted.
6) To keep the lateral balance, i marked all positions including esc and the battery position.
This mean to keep esc /battery in centerline of fuselage.
Hi flyingboxcar,
7) CG -mentioned in manual -75mm from fuselage,will check on this after turning the plane up side down.
Has the tail wheel been stuck in the rudder -very soft ,any better suggestion
tail wheel fix can be tricky, watch out
9) will reduce throws to 20 -22%
Do I need to adjust the trust line i.e two deg down and 2 deg right ,could I but a washer on upper bolts & on the left.
how did you install the ESC & RX ? Did you velcro them .
Any other suggestion is still welcomed.
regards
peter