Although the beep pattern differs from ESC to ESC but the setup and procedure remains same usually.
The procedure for calibration is as follows:
1.) Disconnect the battery and all previous setup.
2.) Install your receiver and connect the ESC wire to the channel 3(Throttle) of your receiver.
3.) Now switch on your radio and increase the throttle to maximum.
4.) Now connect the battery.
5.) You'll hear beep pattern. Although it is somewhat different in different ESC's but on the second beep you need to bring throttle to zero. Disconnect the battery and connect it again(Keep throttle zero after disconnecting the battery)
Now your ESC is calibrated.
I hope after this your problem would get solved.