Title: Edge 540 3D foamy plan built - for Sweepstakes 2014. Post by: pawan.pandey on April 15, 2014, 03:02:01 PM Friends,
I wanted to share the build of my first 3D airplane - Edge 540 - a profile plane Plans taken from here : http://www.3dfoamy.com/plans//Edge540_Plans_D_Tiled.pdf (http://www.3dfoamy.com/plans//Edge540_Plans_D_Tiled.pdf) Will use 3 9 Gm servos : One for ailerons, rudder and elevator. 2212-1200kv Emaxx motor. 9x6 prop. 2200mah 3S Lipo Title: Re: Edge 540 3D foamy plan built - for Sweepstakes 2014. Post by: controlflyer on April 15, 2014, 03:05:14 PM what size are you planning to build ?
asked because the 2200's look a bit bulky for a average sized profiler Title: Re: Edge 540 3D foamy plan built - for Sweepstakes 2014. Post by: pawan.pandey on April 15, 2014, 03:07:13 PM I dont have any other Lipo... so will have to use it.. The size of plane will be exactly as in the plans.
Title: Re: Edge 540 3D foamy plan built - for Sweepstakes 2014. Post by: controlflyer on April 15, 2014, 03:07:38 PM sorry, the *.pdf was still opening when I typed the above.
Seems good to go! Refer to the prop selection chart in that line drawing. best of Luck! CF Title: Re: Edge 540 3D foamy plan built - for Sweepstakes 2014. Post by: sundaram on April 15, 2014, 03:14:30 PM If I remember correctly it was only 1300-1600mah 3S recommended. 2200mah too bulky.
Title: Re: Edge 540 3D foamy plan built - for Sweepstakes 2014. Post by: pawan.pandey on April 15, 2014, 03:16:48 PM Printed the tiled plan on to A4 and stuck them together.
Ensured the scale was correct. Then started the build with the fuse - Very very easy. Traced on to some HD thermacole sheet and cut out with a knife... Title: Re: Edge 540 3D foamy plan built - for Sweepstakes 2014. Post by: pawan.pandey on April 15, 2014, 03:21:10 PM Thanks sir. Will borrow a smaller battery from Gaurav sir to use.
Will use HobbyKing 9gm servos. Pushrod will be 2mm solid CF rods. WIll make the wing removable to help in carying. |