|
Title: MY FPV FLYING WING FROM VORTEX-RC Post by: MKARTIKGANDHI on February 27, 2015, 01:40:06 PM it fly great and be careful about right centre of gravity otherwise it will put you in panic mode
Title: Re: MY FPV FLYING WING FROM VORTEX-RC Post by: MKARTIKGANDHI on February 27, 2015, 01:44:40 PM and this is what happens when you launch a wing wrongly .... three stitch on my finger due to propeller cut
Title: Re: Re: MY FPV FLYING WING FROM VORTEX-RC Post by: arun.sreelakam on February 27, 2015, 01:47:53 PM Wings must be launched by holding uts wings
Title: Re: MY FPV FLYING WING FROM VORTEX-RC Post by: ashimda on February 27, 2015, 07:22:31 PM Arun in absolutely right. Wings can be launched in a number of ways but the safest way is by holding the wing.
http://youtu.be/gceaAAIcsck (http://youtu.be/gceaAAIcsck) Title: Re: MY FPV FLYING WING FROM VORTEX-RC Post by: sahilkit on February 27, 2015, 07:57:07 PM That was a close call, you were flying alone.
Recover soon and fly safe. Sahil Title: Re: MY FPV FLYING WING FROM VORTEX-RC Post by: shobhit17 on February 27, 2015, 08:47:47 PM Dear Friend.... well I too have a vortex Speedster and been flying it well without any issues. If you have downloaded the booklet on how to build the model from the internet..... it also gives you a link of you tube videos on how to do the preflight and launch for the model. Please go through it as it will be of immense help and your model or you some more injuries...
The links for both the two things are given here..... By the way that is Mr Gaurav in the video i.e. the owner of Vortex RC....:- https://www.youtube.com/watch?v=LQJX2425Ito (https://www.youtube.com/watch?v=LQJX2425Ito) https://www.youtube.com/watch?v=eXx_MlHICc8 (https://www.youtube.com/watch?v=eXx_MlHICc8) Happy flying..... Title: Re: MY FPV FLYING WING FROM VORTEX-RC Post by: MKARTIKGANDHI on February 28, 2015, 02:51:19 PM thanks guys for all the vital info
@sobhit what is your flying weight of speedster pro by manual it should be 850-900 gms and i think i am around 600 gm could it be the possible reason for very sensitive controls when flying with more the 40% throttle power it fly very good around 25-30 % power but above that tends to climb and get fair bit glitchy in nominal wind conditions Title: Re: MY FPV FLYING WING FROM VORTEX-RC Post by: pravesh736 on February 28, 2015, 03:37:30 PM With the correct cg, control surface of wings are very sensitive. U need only or less than 50% of throws, so set dual rates or expos .
Also- Pitching up with throttle is normal but should not be extreme. Title: Re: MY FPV FLYING WING FROM VORTEX-RC Post by: shobhit17 on March 05, 2015, 09:13:42 PM Dear Gandhi you may kindly check the spelling of my name and write it correctly please. OK... You may recheck the CG of your wing. If it is even a wee bit rear the model will be very sensitive and climb rapidly on increase of power. If the CG is fine then you may use the expo mode of your transmitter and reduce the control throws to -30 to - 50. This will give you the sensitivity you are looking for. I use -40 on the Ailerons and nil on the elevators..... well I do throw around my model a lot making it do a lot of aeros.....
Best Wishes. Shobhit |