This is what Spad World Reccomends for ESPA 3D-

MOTOR-GWS EPS 350C/BB engine with a 6.60:1 gearbox

PROPELLER-GWS EP1260 (12 x 6) prop

BATTERY-7 cell 8.4V AAA 720mAH Ni-MH flat pack

ESC-Castle Creations Pixi-20P

SERVOS-HS-81MG servos

Now due to high shipping cost of Foreign Websites I selected the following Substitutes from Different Indian Websites-

MOTOR-Aeolian C2830 KV1300 brushless motor(Rc Bazaar)

ESC-Avionic 20Amp(Rc Bazaar)

SERVOS-Same as Recommeded(Sharma Aero-Models)

Tx-Rx-FS-CT6B 6ch 2.4GHz transmitter & receiver-(Rc Bazaar)

Are the products that i have selected right if wrong please tell me what should i buy.

Warm Regards And Please Reply.

sorry adyonfire i missed the post, i started it with a motor with gear box from gws, used 12*6 slow fly prop, later i moved to a brushless setup with no gear box, i t's too late now i will post the correct details tomorrow,i would suggest you build with 2mm coro and reinforce with some carbon rods.dont go for the hs 81mg hxt 900 is more than enough