Greetings everyone, just like everyone else, I was bored in quarantine and decided to make my own "EDF" with the parts lying around in my house.
Specifications:
EDF outer diameter: 120 mm
Propeller diameter: 5 inches
Blade count: 3
BLDC motor: A2212 6T 2200KV outrunner
ESC: General 30 Amperes
Battery: 1500 mAh 3S 30C
AUW: 120 grams
I would like to know if this is a safe setup. Am I fine running it off of a 30C discharge rate battery or will I end up frying my motor or worse, both my battery and motor? I don't plan on using this as an engine for any of my builds. Just made this for experimental purposes.
Thank you,
Surya Krishnakumar