Guys,

Need some help... I recently bought a small RC heli, Copter V-Max Hypersonic 6020. I have charged the helicopter and new batteries loaded in the remote.
Switch on the remote and I have 9 lights light up. I switch on the heli, ( the lights flash on).
Now, I toggle the throttle switch 'n' number of times, the the helicopter blades do not spin.

Is there something i can do to sort this out...? To me it seems like the remote is unable to connect to the heli..(IR)

Only on one occassion did the remote beam and show 3 lights and the heli started off. But, not since then.

Rgds,
mclaren4u

Can't find any manual online

Are you using 1.2v alkaline batteries, or regular 1.5v AA cells ?

its basically gyro inside it will take some time to initialize ,prior to that you shld not move control stick and i think there is a rudder trim knob to trim rudder try turning that one ,same problem was with my 9074 heli!

Do you have infrared remote transmitter..?
If so then you should adjust the frequency using ABC switch on your transmitter.

I have tried adjusting the trim. Also, been switching between the channels. The only time, the heli lifted off was on channel C. It happened only once..!!

I have attached some pics.. this is the current state. I dont see the heli syncing with the xmitter.

Rgds,
mclaren4u

I am using the regular 1.5 AA cells. As far as I could understand, there is a trim knob on the right side of the xmitter. I could see a knob on the left, but it does not move. Is that correct?

As it was lifted when nob was on C, you should keep it on C.
You said it lifted only once, Is your fan rotating in this condition...?

check list
ensure the following

1. Batteries are charged both remote and Heli.
2. Remote and heli are on the same channel (in this case channel C)
3. check for loose wires or jammed gears if it crashed after the first flight.

Be very specific of what happend to the heli after the first rotation only then you will get an answer which will solve the issue.

Hope the above info helps.

Hellyflyer