Hi Rotarians.Need your help in setting up my mini Vbar on the Trex 550.It has got a DFC head and am getting too high a value while trying to attain the recommended collective pitch of 12-14 degrees and the cyclical is also way off.To attain 8 degrees, the value on the slider hits as low as 60.The blade links are on the inner hole of the standard align cyclic servo arm.Tried and tried but end up frustrated every single time.Read similar problems on other forums where most of them switched to KDE arms or used shorter servo arms.Can't the Vbar set up with the native align parts,without using third party upgrades?Also,if I use shorter servo arms,the links won't be parallel to the main shaft.What will be it's impact on the flight characteristics?Pls chip in.