RC India

Hi all,

  My reptor 90 is giving glitch when I am starting function test with remote . i chckd there is no other similer frequency matching in near around area . can any one pls help me on it ?

anil .

[Admin Note] Changed "wen m" to "when I am" in topic name and post.  SMS language is not tolerated here, please type in readable words.

HiAnil,

Can you elaborate more on the word glitch?. What kinda radio are you using?

Wen I start my heli n remote both for function check , heli gives out of control movement frm throttle to tail . CN u pls wat should I check ?

Have you chosen the right model in the TX ? Is the programming reset ?

Can you further define "out of control movement" ? Does the heli controls keep on moving by itself even if you are not moving any TX sticks OR, for example, does the heli swash tilt to the left when you give right aileron control ?

Again, please do not use SMS language, it only takes a few seconds extra.

+1 to what Anwar ji said. Looks like you getting a lot of vibes but do check the swash movements. Double check ur receiver connections, a loose servo connection or a loose fit satellite receiver (if any) can cause one or the other symptom.

Get help of an experienced pilot near you. Raptor 90 is extremely powerful machine so dont get impatient.

If you can make a small video it can help us to pinpoint the prob.

Once I start my remote which is hitec spectra 2.4 GHz heli control keeps on moving itself even if I am not moving any tx stick . CN u guys pls give me ur wats app number so I Can give u video asap . My number is 9022919838 .

is it only one servo or all the servos ?

All servos

move a few feet away - Does it still do it ?
go to range check mode - does it still do it ?

if answer to both above is yes then

1. check your tx and rx antenna
2. check the voltage being supplied to rx (are you using an rx pack thru bec ? or nimh pack ?)

+1 to Saikat

I did both . But prob still same !
 m using rx throgh bec.

Use  a separate battery pack to power your Rx and disconnect the BEC

do you have a spare RX - try with that

you are talking about servo glitch , try switching the servo into another port and see if the problem follows the servo or the port.

Are you using a 4.6v or 6v Rx battery? Are you using a voltage regulator?

Using 4.6 battery n nt using voltage regulator

If you got spare receiver use it and see if the prob continues.

Ok I will get one receiver ten let knw hw it works

Any update?