Hello ,
So I am here , posting after a while . My exams are just about to end and I can go ahead with my tarot 450 pro fbl build . All the stuff has arrived . I have some questions regarding the tx programming :
I would request the help of forum members having experience with the ROBIRD G31 . I did check CPO Helis youtube videos and did not find these answers . Again , I could not use other info as the robird software specifically asks to set transmitter settings and it is not like a normal 6ch heli set up . Please help me if you have the knowledge as this is my first build . Thanks In advance
So here are my problems :
1 ) My transmitter has all trims etc turned off , all curves at -100 -50 0 50 100 ( linear I guess ) .... The swash is set to 90 with no collective or any mixes . . . . Now start my problems
My channels are 1 throttle
2 Aileron
3 Elevator
4 Rudder
5 Gear ( I hope it should be gear )
6 ( I dont know what to put here)
and if I flip the gear switch , then on the robird setup guide screen I see the blue meter toggle between FULL AVCS and full RUDGainRate ... So am I ok there ?
Btw my transmitter has no gyro switch or anything . And on flicking the gear switch I can see the robird unit switch between a red light and a blue light . I have no idea what they mean . Also I did not find any gyro setting page in my transmitter menus . Turnigy 9xr .
Please help me with the channels .
Question 2 :
How do i set idle 1 , idle 2 settings ? Do I set them in the transmitter or set them in the robird ?
And in my transmitter my throttle curve is linear . So that means at low position throttle 0 ..
But my pitch is also linear and have set it as such that at the robird software I see 0 pitch at mid throttle ... Full pitch at full position and full negative pitch at low throttle position
Now , I am running PWM mode with a normal receiver . My ESC throttle cable goes into the receiver channel 1 directly and not into the robird . As a result I see no input on the ROBIRD software in the MOTOR:low , high bar . . . But In some videos I saw that the motor and pitch moves together in the Setup guide screen. Have you connected your esc to the robird ?
Again I am lost on what to do .