Hi All,
Here is a part list that I used to build a Quad. This is still in works and I hope to complete it this weekend or best case next weekend. Let me know; if I could have done better or if you have any suggestions.
Once I fly this one; I plan the following:
- FPV
- OSD
- May be a Naza / APM for RTH (Return To Home)
- Increase the range from say 1KM to say 2-5KM (I have no idea how I will do this; however, this is on my "To Do List"
- Attach a Gimble
- What else can be done?
Quad Main Body:1 x KK2.1 Multi-rotor LCD Flight Control Board With 6050MPU And Atmel 644PA
2 x Carbon Fiber Propeller CW/CCW 10X4.5
4 x T-Motors MT 2212 980KV
1 x Turnigy H.A.L. (Heavy Aerial Lift) Quadcopter Frame 585mm (I had ordered 1 x X600 Fibreglass and Aluminium Frame with Short Stands and it did not work for me as the quality is not what I expected. The Aluminium rods are flimsy and the fasteners are of poor quality)
4 x SimonK ESC 30A
1 x LIPO 5000mah 11.1V 20C/40C
Transmitter/Receiver:1 x FlySky FS-TH9X 2.4G 9CH System (TX + RX)
Miscellaneous:6 x Female to Female Servo Lead
1 x XT60 to 4 X 3.5mm bullet Power Breakout Cable
1 x XT60 female to DEANS male connector
2 x Velcro Battery Strap 20x220mm
2 x 3.5mm Gold Connectors 10 pairs
1 x 16 AWG Black Wire 1 mtr
1 x 16 AWG Red Wire 1mtr
2 x Adhesive Velcro Strap 50mmx1m
2 x 5mm Heat Shrink RED
2 x 5mm Heat Shrink Black
Print
