Title: Choosing a landing gear for quadcopter. Post by: RD1452002 on May 17, 2014, 11:03:06 AM I'm building a quadcopter with-
Z450 FlameWheel Flame Center without circuit board Frame from http://www.quadkopters.com/product/z450-flamewheel-flame-center-without-circuit-board/ (http://www.quadkopters.com/product/z450-flamewheel-flame-center-without-circuit-board/). -and- an FPV Pan Tilt With 9G Servos from http://www.quadkopters.com/product/fpv-pan-tilt-with-9g-servos/ (http://www.quadkopters.com/product/fpv-pan-tilt-with-9g-servos/). So I need a landing gear for my quadcopter which is tall enough for the FPV and I also strong enough to bear 750g. I am confused ??? between: DIY Universal Landing Gear Set from http://www.sp4mm3r.com/diy-universal-landing-gear-set.html (http://www.sp4mm3r.com/diy-universal-landing-gear-set.html) -and- M200 Crab Leg Landing Gear Set DIY from http://www.sp4mm3r.com/m200-crab-leg-landing-gear-set-diy-red.html (http://www.sp4mm3r.com/m200-crab-leg-landing-gear-set-diy-red.html). I don't know the height of the DIY Universal landing gear so I'm asking this question. Suggestions are welcome and my budget for the landing gear is under ₹1500. Or should I make a landing gear just out of thick wires and and small hollow aluminium rods. Title: Re: Choosing a landing gear for quadcopter. Post by: Shyam Hembram on May 17, 2014, 02:33:51 PM check from Rc bazaar,it's about 1400
|