|
Title: F450 Quadcopter kk5.5 Calibration problem. Post by: smithraj on December 25, 2015, 07:00:31 PM Hi Brother,
I have a problem. Here i give the step by step what i do. 1. I connect receiver wiring. 2. I connect all 4 motors wiring correct as per diagram M1 to M4 3. Trim the YAW in 0 4. Transmitter ( HK T6A V2 - 6 ch Mode 2 ) switch ON 5. Throttle stick UP position 6. Connect the Battery, & Blink the blue LED 3 time & all calibration process ok ( Tx switch on position ) 7.Then Down the Throttle., 8. While UP the Throttle ., all the motors runs as per diagram.( clock ,Anti,clock,Anti) 9. Disconnect the battery., ( Tx switch on position ) 10. YAW in Maximum position ( Tx switch on position ) 11. connect the battery - ( Then all motors vibrate with beep sound ) ( Here is my big problem ) 12. Increase the throttle ., Nothing Happen of M1 to M4 13.The Kk5.5 board goes on calibration mode( Here is my big problem ) so pl solve the problem & pm me. I make this calibration step in 8 times., But nothing happen smithraj :banghead: Title: Re: F450 Quadcopter kk5.5 Calibration problem. Post by: puneet123456 on February 15, 2016, 03:24:53 PM Where i can get this potentiometer value 10 k ohm
Title: Re: F450 Quadcopter kk5.5 Calibration problem. Post by: Sukhpreet on February 15, 2016, 07:08:34 PM BUT DID YOU BIND YOUR RECEIVER TO YOUR TRANSMITTER ...?
Secondly if i am not wrong(Which i could be) did you flash the right program on kk 5.5 ?? Because i think it doesnt come with installed/flashed program....You need to select the right model and configuration ...Then as per that select the file.. to be flashed...Then flash it..... http://www.robotshop.com/media/files/pdf/user-manual-kk-control-package.pdf |