dude this is my first build.. and my parents will kill me if i tell them that you are saying this.. so 10 amp is fine.. most of the people use 10 amp with 2400kv motors.. so lets experiment once

so use 5030 two blade prop with 10Amps ESC. coz it draw 9A current with this props.. so don't worry it will heat..

regards

Darshan try putting the esc nearer to the motor(under the blade) might ward off some heat(it does! ) and escs will be cool

thanx will try that

Happy Flying and please do post a video of your tricopter flying!

now it is becoming too hot to touch and there is some smell of electricity( short circuit).. I think there is some problem.. the control board problem has occured again.. the red lights are blinking and then going off and same for the blue although it is shorter than the blue one .. then the board would kind of lose power and completely blank.... PLZ HELP

Isn't it you who earlier stated that your LiPo became damaged when just connected to ESC ?
Let me ask you one thing, Have you found out exactly what happened that time ? Are you using the same setup you used that time ?
On going through your profile, I came to see you have made too many threads  on the same or related topic. As you are new here I don't blame you. But I would suggest you create one thread, that deals only with this Tricopter build of yours. (I assume this is your first build) . You should consider the following while creating that thread ,
1) Give a Detailed List of your setup (parts used)
2) explain the problems you have faced .
3) give all the details of this build till now.

I can assure, you will get far better help in troubleshooting all this problems, if you make such a thread. this is because people can get a clear view of what you are trying to do, and what exactly happened.

Making such a thread that deals with only the build of this tricopter will make your readers understand what went wrong and where.

first try to put esc servo wire to channel 3 of your receiver , connect motor and run.. and check weather it heats up again or not.. check all the esc in same way..

regards

this kind of remote control diagnosis is very difficult if you are a complete
beginner.

if you are interested in realtime troubleshooting then pm me
and i will give you my cell no and you can call.