|
Title: NAZE 32 and 12A ESC- wiring? Post by: anilntny on July 07, 2015, 06:03:16 AM I am using emax 12a simoK esc with cc3d ,with all wires intact.I mean ,I have not removed red power wires from three ESCs as many do-keeping only one intact.
Now since I am going to use NAZE 32 funfly for my next build,should I remove them? .I am using emax 12A again. Title: Re: NAZE 32 and 12A ESC- wiring? Post by: Darshan for multirotors on July 07, 2015, 06:24:10 AM There is no need to remove if your esc's have built in linear Bec
Otherwise remove the red wire Title: Re: NAZE 32 and 12A ESC- wiring? Post by: anilntny on July 07, 2015, 07:32:42 AM Thanks Darshan,they have Built in linear or switched BEC.
Title: Re: Post by: sooraj.palakkad on July 07, 2015, 07:53:00 AM They have linear BECs , Anil sir, thus you can use as is.
Title: Re: NAZE 32 and 12A ESC- wiring? Post by: anilntny on July 07, 2015, 06:48:59 PM :thumbsup:
Title: Re: NAZE 32 and 12A ESC- wiring? Post by: ilyas ali on January 01, 2016, 11:39:09 AM Hi
i read your post and found you are working on naze32. i am using naze32 10dof flight controller 12a blheli esc and done calibration but once armed my motors not rotating in sync. the motor i am using is emax mt2204. can you help me to sort out this. |