Title: Need Help with naze32 and turnigy 9x Post by: desachristopher on August 03, 2017, 11:07:40 AM I have assembled at quad 450 size frame with naze32 full. the transmitter Im using is Turnigy 9x with stock firmware,
problem is when I connect the controller to the Receiver. and checked when I moved the throttle, pitch is moved on cleanflight. and when I move the pitch on transmitter, throttle is moved in cleanflight. then I interchanged the wires on receiver. then everything was showing fine. but when I try to fly the quad, it flips before takeoff. I checked everything, motors are turning correct. I balanced the props. FC is also in correct position , accelerometer calibrated. PLZ HELP.. Title: Re: Need Help with naze32 and turnigy 9x Post by: saikat on August 03, 2017, 12:31:32 PM there should be a setting in the cleanflight confg - channel allocation - AETR or -TAER
in your case it should be AETR. -( aileron , elevator , throttle , rudder) put the wires in the correct order back on the receiver - and you should be good to go. please wait for others to respond also - it is a long time (2yrs) since I have done multirotors and i am writing from memory. Title: Re: Re: Need Help with naze32 and turnigy 9x Post by: desachristopher on August 03, 2017, 01:44:43 PM there should be a setting in the cleanflight confg - channel allocation - AETR or -TAER Thanks buddy. I,ll try once m homein your case it should be AETR. -( aileron , elevator , throttle , rudder) put the wires in the correct order back on the receiver - and you should be good to go. please wait for others to respond also - it is a long time (2yrs) since I have done multirotors and i am writing from memory. Sent from my Redmi Note 4 using Tapatalk Title: Re: Need Help with naze32 and turnigy 9x Post by: desachristopher on August 03, 2017, 04:33:42 PM no luck. still same. check screenshot
Title: Re: Need Help with naze32 and turnigy 9x Post by: saikat on August 03, 2017, 10:00:12 PM another point - in your tx go to menu - system settings - stick set
it should be mode 2 . i assume your throttle is left stick |