RC India
Welcome Guest, please login or register.
 
Pages: [1]   Go Down
0 Members and 1 Guest are viewing this topic. Topic Tools Topic Tools 
Read
« on: September 02, 2015, 01:58:08 AM »
abe7468
Plane Lover
Active Member
**

Reputation Power: 1 
abe7468 has no influence.
Offline Offline

City: Rajahmundry
State: Andhra Pradesh
RC Skills: Beginner
Posts: 2
Join Date: Jan, 2015




Hi guys . I am new to the hobby and recently brought a quadcopter from RcBazzar.com.http://www.rcbazaar.com/product.aspx?productid=4571.  I finished putting it together and charged the batteries. I got a new flight controller the KK 2.1 The TX is avionics RCB 7i. Batteries are 3c, 11.1v wolfpack 2200mAh . I did all the calibration and ESC calibrations.  I checked all the controls on the screen of the KK2.1 Every thing was OK. After checking the gyro bubble I armed it and tried to fly. I also set the trims to 0. As I was flying Indoor i couldn't give more throttle. But with the little throttle that I gave it started going to one side even before taking off. I tried adjusting the PI values according to the manual but to no avail . I tried turning the self leaving on and off but also no use. I calibrated the whole thing many times but no change. I will go out side and try to give a little bit more throttle and see if I can correct the movements in flight. Plz as i am a newbie any suggestions are welcome. Thanks in advance. If needed I will post a video showing the quad.
Logged
 

Read
« Reply #1 on: September 02, 2015, 07:14:47 AM »
Darshan for multirotors
Well now it flies!!
Heli Lover
Forum Hero
*****

Reputation Power: 11 
Darshan for multirotors has no influence.
Offline Offline

City: Mumbai
State: Maharashtra
RC Skills: Beginner
Posts: 855
Join Date: Feb, 2015



Put it in self leveling mode and take it off the ground... There is quite a lot of resistance near the ground so it tends to drift.
Just go outside, take it up a considerable height and see.
And the copter is not going to stay perfectly stable until you have a gps system on the flight controller. You will have to keep correcting it.....
Happy flying
Logged

put your heart in flying and flying will never leave your heart
 

Read
« Reply #2 on: September 02, 2015, 08:05:08 AM »
santanucus
Plane Lover
Forum Veteran
****

Reputation Power: 5 
santanucus has no influence.
Offline Offline

City: Kolkata
State: West Bengal
RC Skills: Beginner
Posts: 396
Join Date: May, 2015



Almost every beginner faces this tilting problem. Sometimes its the wrong rotors in wrong positions or the wrong motors in wrong positions. Even incorrect direction of the controller. In my case, it was ESC cables going into the wrong pins of the flight controller's output. I don't have any idea about the KK board as I built one with APM but
Logged
 

Read
« Reply #3 on: September 02, 2015, 08:38:44 AM »
rajsachdev
Heli Lover
Senior Member

***

Reputation Power: 2 
rajsachdev has no influence.
Offline Offline

City: Mumbai
State: Maharashtra
RC Skills: Beginner
Posts: 102
Join Date: May, 2014



Tilting/ flipping is a problem almost every newbie has to go thro'. There is a simple test i read elsewhere on net and use it to test every new build.

Arm and apply throttle so props are spinning fast but craft doesn't take off. Move roll stick to left the right side should lift slightly, move roll stick to left the right side should lift slightly, similarly you can check pitch by moving sticks slowly to front and back the back or front should lift properly. If this works then your motor and prop orientation is correct.

I suggest you use default PID's in beginning don't change them till you have a lift off and some familiarity with flying it.

Most of the time the problem has been wrong motor direction or wrong prop mounting, if both these are correct the order of motor wired to FC may be wrong. There may be other problems but these are most common.

KK2.1 is a good beginner FC an can fly almost anything as long as wiring and direction of motors and props is correct.

Good luck...

Logged
 

Pages: [1]   Go Up
Jump to:  

Related Topics
Subject Started by Replies Views Last post
Newbie help needed ! « 1 2  All »
Beginners Zone
Anjan 26 37966 Last post January 11, 2015, 05:45:45 PM
by chetan04
Another newbie here..
Multirotors
hypd09 3 2686 Last post November 13, 2012, 12:34:02 AM
by anand21nanda
X3 Newbie
Helis
Cary101 6 4112 Last post December 05, 2012, 03:55:37 PM
by raja_mastana
Need help for a newbie
Beginners Zone
v2 eagle 4 4553 Last post August 04, 2013, 09:10:24 AM
by rcrcnitesh
Quadcopter Build - Suggestion required for newbie
Multirotors
blackhawk_sourav 7 3202 Last post March 26, 2016, 09:43:46 PM
by ashimda