|
Title: problem regarding setting up turnigy 9x with naza lite Post by: gunnu on January 26, 2015, 07:02:27 PM hello friends..
i am posting this on behalf of @massguru i have an problem regarding setting up naza lite with turnigy 9x.( upgraded to v2 firmware ). i setup my hexacopter completely but facing an issue.. after arming hexa motors start spinning but motors speed remain constant till the throttle stick reaches 70% and after 70 motors speed up very fast and falls to one side.. ( same problem when setup it with naza lite firmware)... :help: :help: :help: don't have any knowledge about radio... if any expert in delhi, noida can help me.. i can visit him.. thanx regards massguru contact no. 8860040979 :help: :help: Title: Re: problem regarding setting up turnigy 9x with naza lite Post by: massguru on January 27, 2015, 12:56:15 AM Thanks @gunnu
Title: Re: problem regarding setting up turnigy 9x with naza lite Post by: sooraj.palakkad on January 27, 2015, 05:35:25 PM The problem may be due to Improper throttle curve settings. Check 'throttle curve' setting on your Radio it should be linear (diagonal line from bottom left corner of graph to top right corner.) - If you don't understand what i mean, i can post pics of the curve on my radio setting.
Also check whether any unwanted mixes in turned ON on your Radio. If you are completely noob on radio settings, just Factory reset your radio, and try again. Title: Re: problem regarding setting up turnigy 9x with naza lite Post by: massguru on January 27, 2015, 06:09:22 PM @sooraj.palakkad
Kindly post the picks of settings. Thanks and Regards Title: Re: problem regarding setting up turnigy 9x with naza lite Post by: sooraj.palakkad on January 27, 2015, 07:27:29 PM Here is the Throttle curve (This is on my Flysky FS-T6 radio, however the graph should be like this on your 9X too)
Title: Re: problem regarding setting up turnigy 9x with naza lite Post by: massguru on February 07, 2015, 09:09:46 PM Is this ok?
Title: Re: problem regarding setting up turnigy 9x with naza lite Post by: sooraj.palakkad on February 07, 2015, 10:54:55 PM Ok that is enough.
Now is there any improvement in flight ? As I am currently using NAZA, i learned how to set it up :) I think I can help you better now. If it is still showing problems, I would recommend you to clear the transmitter model memory , and do the Tx calibration again. Do the sensor calibtration and try again. I assume that all your connections, motor rotation, prop direction, Flight controller mounting is correct. Title: Re: problem regarding setting up turnigy 9x with naza lite Post by: massguru on February 23, 2015, 07:49:50 PM Thanks to all.
Cheers |