RC India

i have decided on the basic wiring setup of the quadcopter which i plan to make. i am alsoin the process planning on creating a complete build log of it. the parts have arrived at mumbai customs i have to go to pick them up.

please point out any mistakes which you may find in the wiring or things i might have missed


Subbu

Looks perfect setup. So long flight time is your requirement?

yes i was hoping for a longer flight time. since i am probably going to be buying a gopro for it or another cheaper similar quality solution i would like to have some extra time.

the all up calculated weight comes to about 1099.8 grams
my NTM PD 2826 give about 652 grams of thrust at 10A with a 9x5
so i guess hovering at half or bit more stick should be fine

Subbu

Nice to hear from you. Wish you all the best. Hows NTM motors?

hi dharmik, thanks, i shall have them with me by Tuesday i can further comment on them then but as far as i have heard on rcg and hobbyking forums they seem to do the job fine

by the way i have followed your quadrotor from bharuch thread and you seem to have done a very fine job there congratulations on that.

i am using this frame http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=20947 (http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=20947)

and i plan to replace the landing skids with something more durable any ideas(i think you mentioned somewhere about the hiller skids)

Subbu

subbu bro i have used this frame and trust me they are not good for quads with more than 800gms.. the moment i moved the stick to more than 50%, due to vibration 2 arms broked :banghead: :banghead:

Again its my opinion choice is yours  :thumbsup: :thumbsup:

Yeah bro it's hiller skids but battery placement is an issue. Needs bit bigger skids. I am thinking to make something like this
http://www.goodluckbuy.com/lotusrc-t380-landing-gear-for-t380-quadcopter-multicopter.html

hi satyagupta i will surely keep that in mind, might even add some reinforcements at vibration sensitive areas like the arm joint at the central plate.

i am also looking into a few vibration dampening methods for the quad will post them when i begin with my build log

Subbu

ahh +1 for that Dharmik bro :thumbsup: :thumbsup: but goodluckbuy is not that good. very poor customer service, none of your mails will be responded. They process your order after 10 days and many more.

I understand that you are just pointing towards the kind of skid that we can use :thumbsup:, but hearing goodluckbuy :banghead: :banghead: my blood just boils up recently one of my purchase came to me after good 50 days i placed order >:( >:(

Oh man 50 days is too much. However i heard that they don't reply any of your mail but they are more active on their skype id.