Welcome Guest, please login or register.

[Pikle6]

Tweet

i have decided on the basic wiring setup of the quadcopter which i plan to make. i am alsoin the process planning on creating a complete build log of it. the parts have arrived at mumbai customs i have to go to pick them up.

please point out any mistakes which you may find in the wiring or things i might have missed

Quadrotor Wiring for HK Multirotor V3 Board

Subbu

[Dharmik]

Looks perfect setup. So long flight time is your requirement?

[Pikle6]

yes i was hoping for a longer flight time. since i am probably going to be buying a gopro for it or another cheaper similar quality solution i would like to have some extra time.

the all up calculated weight comes to about 1099.8 grams
my NTM PD 2826 give about 652 grams of thrust at 10A with a 9x5
so i guess hovering at half or bit more stick should be fine

Subbu

[Dharmik]

Nice to hear from you. Wish you all the best. Hows NTM motors?

[Pikle6]

hi dharmik, thanks, i shall have them with me by Tuesday i can further comment on them then but as far as i have heard on rcg and hobbyking forums they seem to do the job fine

by the way i have followed your quadrotor from bharuch thread and you seem to have done a very fine job there congratulations on that.

i am using this frame http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=20947

and i plan to replace the landing skids with something more durable any ideas(i think you mentioned somewhere about the hiller skids)

Subbu

[satyagupta]

subbu bro i have used this frame and trust me they are not good for quads with more than 800gms.. the moment i moved the stick to more than 50%, due to vibration 2 arms broked

Again its my opinion choice is yours 

[Dharmik]

Yeah bro it's hiller skids but battery placement is an issue. Needs bit bigger skids. I am thinking to make something like this
http://www.goodluckbuy.com/lotusrc-t380-landing-gear-for-t380-quadcopter-multicopter.html

[Pikle6]

subbu bro i have used this frame and trust me they are not good for quads with more than 800gms.. the moment i moved the stick to more than 50%, due to vibration 2 arms broked

hi satyagupta i will surely keep that in mind, might even add some reinforcements at vibration sensitive areas like the arm joint at the central plate.

i am also looking into a few vibration dampening methods for the quad will post them when i begin with my build log

Subbu

[satyagupta]

Yeah bro it's hiller skids but battery placement is an issue. Needs bit bigger skids. I am thinking to make something like this
http://www.goodluckbuy.com/lotusrc-t380-landing-gear-for-t380-quadcopter-multicopter.html

ahh +1 for that Dharmik bro but goodluckbuy is not that good. very poor customer service, none of your mails will be responded. They process your order after 10 days and many more.

I understand that you are just pointing towards the kind of skid that we can use , but hearing goodluckbuy my blood just boils up recently one of my purchase came to me after good 50 days i placed order

[Dharmik]

Oh man 50 days is too much. However i heard that they don't reply any of your mail but they are more active on their skype id.