Got back with the tri build today.
Step 1 was setting up motors and electronics on the frame:
RCI 6th Sweepstakes: Tricopter build
RCI 6th Sweepstakes: Tricopter build
Would be using these as motor mounts, got the idea from Flite Test its good, cut from 5mm acrylic sheet.
RCI 6th Sweepstakes: Tricopter build
All assembled together. Now time to add the FC and configure it. BTW i would be using Flip32+ (10DOF) version with this tri as FC
RCI 6th Sweepstakes: Tricopter build
RCI 6th Sweepstakes: Tricopter build
RCI 6th Sweepstakes: Tricopter build
RCI 6th Sweepstakes: Tricopter build
I am using this video by David as reference to configure and tune
I am using the normal 9G servo like this:
http://www.hobbyking.com/hobbyking/store/__662__HXT900_9g_1_6kg_12sec_Micro_Servo.htmlWhich i think is not a good choice
since i am not good with tricopter i would like to know opinion about others who have experience in tri.
The servo does not comes back to centre if i move the yaw to extreme left and leave the stick. I have to move the stick to right to get it back to center. But it does not happens if i move the stick to extreme right, if i move the stick to extreme right and leave the servo comes back to centre.
I have a EMAX Metal Digital servo but the head of that servo is bit small compare to TGY09 and does not fits the tilt mechanism.
BTW this is what i meant by head
RCI 6th Sweepstakes: Tricopter build
I might be wrong but i am not aware of the correct word for that part
Any help with the servo would be much appreciated