hi
i have recently bought a rcb os 10 and i have issues with it.
the trims are reverse      ie   if you trim trim to the right it trims to the left on the airplane
i sent it back to rc bazzar pune and  he promised to replace the radio
but sent the same radio back and said thatit was replaced
also i did not recive the neck strap along with my box
plz helllllllpppppp..........

i found the PPM and the GND stream but its not on the transmitting module. it is where the DSC ports are, its hidden under the retracting antenna.

also i would like to add that the trainer function is not working properly

mr suuju plz look into the matter and get my radio replaced plz

hello sagar
pls send an email to helpesk@rcbazaar.com with your order number and will get the needful done... this is an issue of non updation of the firmware which will be done and tested before sending it to you

regards
sujju

what is the range of Avionic RCB OS-10?

With the latest firmware release , a new feature is implemented that allows setting up 6 flights modes for flight controllers like ardupilit easily.
This new feature allows to mix 2 switches to obtain 6 flight mode selections , you can freely select the 2 switches to use and  assign the required PWM value to output for each position.
We know how hard it was to manually setup this mix with other radios. Now it's a piece of cake.

However , we usually used to mix a 2 pos switch and a 3 pos switch to have 6 selections - but as OS- 10 have no 2 position switches , it becomes a bit confusing for the first time user.

I also have the RCB OS10 tx. Wanted to know how can i do free channel mixing example if i wanted to program differential thrust.