RC India

Hi Experts,

i am a beginner here and apologize for this noob question. i have purchased this RCB6i transmitter from rcbazaar a while ago. i tried to bind the receiver with the transmitter as given in the below video.

http://www.youtube.com/watch?v=tI1o3xGf2PI#ws (http://www.youtube.com/watch?v=tI1o3xGf2PI#ws)

the video shows that after a successful bind the LED stays solid RED. However, in my case i see that the LED flashes 3 times and then comes back to blink. i tried this even after changing the batteries in the TX and Lipo battery as well on the receiver side. but no change.

What am i doing wrong?


Thanks
KarSid

Try keeping the receiver far away from the TX. If the receiver wire is too close to transmitter antenna, binding fails many times.

Just release the bind button Immediately after connecting battery. If you keep it pressed it does not bind.

I had taught that I had a similar problem.......But after switching OFF the TX and RX after the BIND procedure  and restarting the same, the receiver light remained solid RED and all the servos and ESC (throttle) worked fine. This showed that the transmitter and Receiver were bound to each other.....Try it out, lets know the result!!

Thanks all for the replies. i have been able to fix the issue by resetting the ID in the radio and trying afresh. However, now i have a strange problem. i using EMAX 4 in 1 ESC and i have no throttle control. while i raise the throttle and cross about 50% or so, the motor powers on at full speed and then there is no control whatsoever on the throttle stick movement. i have tried testing the control using a servo tester and i have perfect speed control from MIN to MAX. So ESC calibration is not the issue here. Any ideas what is the  problem?