just got my RCB 7X and plugged it up right away.....
firstly some features which were missed on the site and the description...
Features
model type : heli, plane
8 alpha-numeric naming for the model
7 model memory
wing type mixing ( flaperon, v-tail, delta)
input selection for gear, flap and aux channel,
wireless trainer function
individual channel assignment( can interchange channel as required
mode selection ( can be changed into MODE 1,2,3,4- may have to interchange the ratchet inside for the throttle hope fully they can do it for you on request)throttle recovery function
dual rates and exponential on ele, ali, rud. with individual switch for each of them.
timer (chrono and stopwatch for timing flight)
6 different user required programmable mixing
throttle idle and throttle hold function for heli, and planes ( incase u wanna avoid powering up of your motor by mistake)
differential function for flaprons
flap throw setting
ali-rud mixing
ele- flap mixing
travel adjust.( EPA- end point adjustments)
sub trims
reversing
adjustable stick lengths
wireless simulator dongle and software included
comes with a 8 cell battery holder pre-soldered with connector... no more soldering of NiCd/NiMH required
some more ( personal likes)
throttle has 34 ratchet locks or clicks unlike futaba/JR which have 24 hence smoother travel
tone changes as u add trims.. as u exceed it increases tone and reduce the tone reduces.
u can see the trimming and input of the channels
looks good.
adjustable stick lengths
some down sides. ( very few and to be corrected. but not much)
antenna has only 180 degree travel around.. and it is on the backside instead of front (a unique feature)
had some trouble in the aliron trimming switch for some time... needs a bit force in beginning to work still a bit harsh
little bad packing. the stick was protruding out of the box.. was lucky... any one might receive a piece with a damaged stick( or pot or bracket may be)
the neck strap buckle is high on top... will need a balancer to use a neck strap properly. ( then the switch will come below the balancer )
no protective film on the LCD. and the LCD is a bit dim.. may be trouble to read in broad sunlight and even small font( may be i am used to the big futaba ones)
charger not included. it may work with std futaba charger with a 9.6V o/p
on a lighter note.
i was expecting a RCBAZAAR neck strap along with the Tx.
and please get multiple receivers in store along with Tx lipo....
will add more once i find time and put the manual CD in the PC and read the manual if it has any added function.
more detailed usage and performance report to be added later. or once i go flying
link to the Tx
http://www.rcbazaar.com/products/1773-avionic-rcb7x-7ch-tx-with-7ch-rx-and-wireless-simulator.aspx