|
Title: Fly Sky CT6B - Channel 5&6 not working Post by: amalbharathan on August 15, 2015, 09:16:59 AM Hi
I am using a flysky ct6b transmitter. when I tried to apply fail safe mode in my hexa copter the channel 5&6 are not responding. Checked it with t6config software. How can I fix it..? Title: Re: Fly Sky CT6B - Channel 5&6 not working Post by: gunnu on August 15, 2015, 11:46:33 AM i don't think ct6b supports failsafe..
regards Title: Re: Fly Sky CT6B - Channel 5&6 not working Post by: harshit batra on August 15, 2015, 12:45:00 PM i am also facing this problem the ch5&6 have only null operation in t6config when it was new everything was working but when i programmed and mixed some channels for elevons that rotating buttons stopped working
Title: Re: Fly Sky CT6B - Channel 5&6 not working Post by: akhilzid on August 17, 2015, 11:05:15 AM CT6B CH5 & CH6 only works if you configured mix and assigned to any POT or Switch,
In flysky no inbuilt failsafe control so cant work failsafe without flight controller, they will output zero pulse when no signal from transmitter so failsafe works with Naza, APM and Pixhawk, don't know about other flight controllers. for this we need to configure failsafe in flight controllers configuration. Title: Re: Fly Sky CT6B - Channel 5&6 not working Post by: anirbanraha91 on October 01, 2015, 12:56:16 PM Hi guys,
Could you tell me how the Flysky FSCT6B transmitter and receiver is in general? I mean how is it quality wise? Is it worth buying? Title: Re: Fly Sky CT6B - Channel 5&6 not working Post by: sanjiv1994 on November 25, 2015, 11:41:40 AM I have one brand new CT6B , sealed packed and willing to sell it.
Title: Re: Fly Sky CT6B - Channel 5&6 not working Post by: shobhit17 on November 25, 2015, 12:34:40 PM Its OK does not have any glitches and is affordable. The Range is good enough for line of sight flying. I have been using it for about 2 years and am changing my set to a FUTABA T6K in Dec.
|