Title: fs-i6/FS-A6 weird behavior Post by: sim_tcr on November 17, 2018, 10:12:50 PM Hello,
I have a FS-i6 Tx and FS-IA6B and FS-A6 (PWM only) Rx. Both Rx are binded to Tx. IA6B is my INAV quad's Rx. FS-A6 is a test Rx with a servo connected to ch6. Irrespective of any model I select in i6, FS-A6 will be listening to Tx. For eg, If I select model for FS-IA6B and turn VRB knob, servo connected FS-A6 to will respond. In FS-IA6B (INAV) ch6 is unused. Any one else experienced this behavior? I am building a 2 axis gimbal using 2 servos and an old cc3d atom FC flashed with an old version of INAV. I wired above FS-A6 receiver to cc3d so that I can tilt the camera using the pitch axis. I want to use this gimbal on my INAV quad. I was thinking of a way to control the camera while INAV quad is flying using the same Tx. Can I make use of above bug in favour of me? I tested and it works. But before I fly real time, Is this ok to do? Note: I do not have enough PWM ports on my INAV FC, thats the reason a dedicated FC is used for gimbal. Thanks. |