|
Title: Questions about HK 2.4GHz 6 ch(Mode 2) Post by: mrhot111 on March 02, 2011, 08:48:20 PM Not my own but we 5 friends have bought it.
Which battery should we use with it, tx lipo or duracell is nice for long run? There is nothing in transmitter to connect li-po. How can it be connected? And there is a charging port on side of Tx, for which type of battery that is used? Title: Re: Questions about HK 2.4GHz 6 ch(Mode 2) Post by: prateek13 on March 02, 2011, 11:04:52 PM lipo recommended
you need to open the tx and solder a connector and the charging point is for rechargeable nimh/nicad battery packs don't charge your lipo using that!!! Title: Re: Questions about HK 2.4GHz 6 ch(Mode 2) Post by: VC on March 02, 2011, 11:18:24 PM I have bought 6 of these Tx/Rx combos and in my opinion, they are a GREAT bargain. Instead of immediately tinkering with it and opening it up to solder connectors /adaptors for LiPo, I suggest you use rechargeable NiMh/NiCd batteries of the Uniross variety. They are good enough. Chargers are also readily available on ebay.
Title: Re: Questions about HK 2.4GHz 6 ch(Mode 2) Post by: mrhot111 on March 02, 2011, 11:29:00 PM thanks prateek, I have 8Ni-cd batteries with charger that can be plugged in Tx, but it is 1.2 v each(1.2*8=9.6v), is it sufficient to run Tx, as normal baateries provide 8*1.5v =12v.
I have never soldered anything, so will not try it first on Tx, so think about lipo after some time. Title: Re: Questions about HK 2.4GHz 6 ch(Mode 2) Post by: prateek13 on March 02, 2011, 11:43:48 PM it will be sufficient as a normal tx need about 9v of power
but see to it that the capacity is good enough Title: Re: Questions about HK 2.4GHz 6 ch(Mode 2) Post by: mrhot111 on March 02, 2011, 11:50:18 PM I have 900 mah batteries. And charger of 12v. Shoud I use that?
|