|
Title: HITEC Aurora 9 with FRSKY DHT-U Post by: paladugu_sujith on June 14, 2012, 02:58:34 PM hello guys
i finally managed to get the 2.4 radio system from frsky. the DHT-U telemetry unit. Hitec Aurora 9 is the best transmitter system I had used , but does not feature PPM Sum . PPM sum feature is possible now with FrSky DHT-U. FrSky DHT-U is firmware upgradable two way transmitter module can be clamped to the transmitter handle/antenna. All-in-one combination of telemetry capable, in-built display and alarm threshold settings featured. This transmitter module can be usable with Hitec, Futaba, JR/Spectrum T9x. Compatible Receivers with DHT-U transmitter module Mode of DHT-U (Selectable on module menu) Compatible Receivers V8 _Mode Non-telemetry receivers (V8FR-HV, V8R7-HV, V8R7-SP, V8R4) D_Mode Telemetry receivers (D8R, D8RSP, D6FR, D4FR) My choice is D8fR 2 receiver. Because RSSI (PWM) and CPPM (8 channel) output , Lighter weight and physically smaller, Fail Safe telemetry capable some pictures are attached and PIN diagrams. Title: Re: HITEC Aurora 9 with FRSKY DHT-U Post by: paladugu_sujith on June 14, 2012, 03:10:26 PM pics
for other radios connection diagrams for pics ..follow this link http://www.frsky-rc.com/uploadfile/201201/20120103190156120.pdf Title: Re: HITEC Aurora 9 with FRSKY DHT-U Post by: paladugu_sujith on December 11, 2013, 10:59:52 AM Done some changes now.. Aurora 9 with dht .
Need to create a new female connector on pcb and now it works flawless.. Title: Re: HITEC Aurora 9 with FRSKY DHT-U Post by: praveen on December 11, 2013, 12:15:17 PM Nice but some messy work ! i did it for my module about 2 months ago! but buzzer was damaged ! so any how i dont use it for FPV flying,so thinking to add when required!
Works good! cheap receivers with telemetry! Title: Re: HITEC Aurora 9 with FRSKY DHT-U Post by: paladugu_sujith on December 11, 2013, 12:43:17 PM i lost my buzzer too.. replaced it with lipo alarm buzzer ,.. works flawless.
Title: Re: HITEC Aurora 9 with FRSKY DHT-U Post by: praveen on December 11, 2013, 12:45:32 PM if it was only soldered we could have removed easily ! but its glued to PCB that's the problem. :)
|