|
Title: HK-T6A V2 not working Post by: vishwasvm on April 15, 2012, 09:58:54 PM My HK-T6A is not working. Only left 2 channels are showing any response. I tried to program it using T6config, Turborix but the result is the same. It can not be programmed. No trim, buttons are working. Throttle is shown centered like other channels. It is reversed and can not be set right.
There is a thread on a similar problem (one channel not responding) where Mr. Roopesh has advised to check soldering and voltages/resistances. I opened and soldering seems (at least to me) Ok to me. Is there a simple solution to this complex problem?? Regards Vishwas |