RC India
Welcome Guest, please login or register.
 
Pages: [1]   Go Down
0 Members and 1 Guest are viewing this topic. Topic Tools Topic Tools 
Read
« on: August 17, 2014, 12:19:20 AM »
K K Iyer
Global Moderator
Forum Hero
*****

Reputation Power: 61 
K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!
Offline Offline

City: Indore
State: Madhya Pradesh
RC Skills: Intermediate
Posts: 5180
Join Date: Jan, 2012




Hi,
Got a Riccs Tx Rx from Jack's with a Fantasia model 3 years ago.
Never used radio due to problems detected during testing.
Now decided to open Tx and check.
Found Tx antenna disconnected (along with general poor quality of soldering on other joints)

RF module is Flysky FS-HF030 Vo.03
From internet pics i guess antenna attaches to top left corner.
That has 3 points.
So where to connect/solder antenna outer/inner?

Help appreciated.
Thanks.


image.jpg
Help- Tx antenna coax disconnected
* image.jpg (73.84 KB, 800x600 - viewed 2122 times.)
Logged
 

Read
« Reply #1 on: August 17, 2014, 08:05:21 AM »
saikat
Plane Lover
Forum Hero
*****

Reputation Power: 14 
saikat has no influence.
Offline Offline

City: Tezpur
State: Tripura
RC Skills: Expert
Posts: 1130
Join Date: Jul, 2009



the outer metallic sheath of a co ax antenna is ground (-) ... so do the following

1 get a multimeter and set to continuity test - should emit a continious beep
    when probes are touched. find out a confirmed (-) negative voltage point in the board

2. put one probe on the negative identified and then use the other to isolate the ground either of the
    the two antenna attachment points. Solder the outer of the co ax to the ground.



   
Logged

 

Read
« Reply #2 on: August 17, 2014, 10:19:43 AM »
K K Iyer
Global Moderator
Forum Hero
*****

Reputation Power: 61 
K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!
Offline Offline

City: Indore
State: Madhya Pradesh
RC Skills: Intermediate
Posts: 5180
Join Date: Jan, 2012



Thanks, but
There are three points at top left.
All three show continuity to ground (bottom left, black wire)
 Huh?

image.jpg
Re: Help- Tx antenna coax disconnected
* image.jpg (43.35 KB, 800x600 - viewed 1755 times.)
This post has 1 more images(s)/attachment(s). Please login or register to view them.
Logged
 

Read
« Reply #3 on: August 17, 2014, 10:41:28 AM »
K K Iyer
Global Moderator
Forum Hero
*****

Reputation Power: 61 
K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!
Offline Offline

City: Indore
State: Madhya Pradesh
RC Skills: Intermediate
Posts: 5180
Join Date: Jan, 2012



Like this pic found online?

image.jpg
Re: Help- Tx antenna coax disconnected
* image.jpg (72.8 KB, 607x618 - viewed 2947 times.)
Logged
 

Read
« Reply #4 on: August 17, 2014, 10:44:40 AM »
sundaram
FAN OF FPV FLYING, AERIAL PHOTOGRAPHY & MICRO RC
Plane Lover
Forum Hero

*****

Reputation Power: 38 
sundaram is working their way up.sundaram is working their way up.sundaram is working their way up.
Offline Offline

City: Gandhinagar
State: Gujarat
RC Skills: Advanced
Posts: 3407
Join Date: Nov, 2009



Middle pad is where the antenna coax core is soldered. The outer two is ground where the outer sheath is soldered to any one. The tx should have survived if you had not switched on for long with a broken antenna. Output stage Would have fried by now if used for long without antenna. Sir try soldering an antenna but best bet is to replace the tx module with any other internal tx  module like frsky,  Turnigy,  Assan,  corona.
Logged

 

Read
« Reply #5 on: August 17, 2014, 10:49:09 AM »
K K Iyer
Global Moderator
Forum Hero
*****

Reputation Power: 61 
K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!K K Iyer is a rising star!
Offline Offline

City: Indore
State: Madhya Pradesh
RC Skills: Intermediate
Posts: 5180
Join Date: Jan, 2012



Thanks. Will give my pencell powered soldering iron some rare exercise!
Logged
 

Read
« Reply #6 on: March 09, 2020, 11:48:09 AM »
Teslamaker
Plane Lover
Active Member
**

Reputation Power: 1 
Teslamaker has no influence.
Offline Offline

City: Mapusa
State: Goa
RC Skills: Intermediate
Posts: 1
Join Date: Mar, 2020



Does anyone have the schematic for  FS-HF030 Vo.03.
My +5v and GND pin when did a short test has a short and i want to find out why .i suspect a voltage regulator short or something but just to be sure .Thanks in advance
Logged
 

Pages: [1]   Go Up
Jump to:  

Related Topics
Subject Started by Replies Views Last post
2.4G Antenna
Cars
traxxrc1 6 5277 Last post December 15, 2010, 08:24:02 PM
by iamahuman
For Sale!! 4 Channel Coax Heli with Gyro « 1 2  All »
For Sale
Hellyflyer 44 21437 Last post July 31, 2012, 12:14:54 AM
by Hellyflyer
3.5 Ch 40 Mhz RTF Coax heli for sale with Wolfpack 1500 mAh 25CBattery(JST Plug)
For Sale
vaibhav27 6 2658 Last post March 30, 2015, 04:28:39 PM
by vaibhav27
Online shop for RF Connectors, RF Adaptors and RF Coax Cables
RC Outlets and Resellers
saintofinternet 0 1638 Last post January 15, 2016, 08:49:49 AM
by saintofinternet
1 cell of 4S LiPo disconnected
Batteries and Chargers
rajjames 2 3954 Last post December 16, 2016, 07:12:18 AM
by rajjames