i want to run just the servo's and so how to give supply to the Receiver
with out ESC, since no motor is being used ....
i'm using this Tx-Rx
http://www.hobbyking.com/hobbyking/store/__16239__HobbyKing_HK6S_2_4Ghz_FHSS_6Ch_Tx_Rx_Mode_2_.htmlthe receiver has channels 1-6 and ID set (binder)
So how do i get it done ... ?
Previously when i once used
http://www.hobbyking.com/hobbyking/store/__8991__Turnigy_9X_9Ch_Transmitter_w_Module_8ch_Receiver_Mode_1_v2_Firmware_.html?gclid=CLqfv633wLICFREU6wodTnwA6git's receiver had channels 1-8 and a Bind - Bat 4-6V option ...., so i connected 4 AA cells in series and so did it .....
Now i don't have that Tx
so how can we do it for the Hk 6 channel one. ....,
can we connect the supply to the bind option to this also ...,
didn't attempt it since it was not mentioned ...
and it does not have spare RX , if any thing went wrong .....
so , did any one attempted this on any similar Tx-Rx ?