RC India

Hi Everybuddy,

I have Turnigy 9x transmitter and its Tx Module is Loose (pic is attached),
due to this I crashed my Assembled HK-250GT on first flight

Can any buddy help me to override this issue,

Also I want to know that from where I can purchase Flysky Module or other compatible module


Thanks
Gaurav Bisht

wrap cellotape all around until it does not
move around ... or you can use lucoplast ..
what the hospital uses to plaster your cuts

Frsky works very well with the Turnigy 9X. You can buy the Frsky DIY module from HK and solder the connections. This will give you no connections at the back so you need not be bothered about loose connections in Module.

Flysky and turnigy modules are same so you will have the same problems in both.

There are lots of internet threads on how to do that. In the mean time go with the suggestions given earlier.

Cheers

get yourself a better radio like the Sanwa, Futaba, JR, spektrum, multiplex etc if want to stay in the hobby for long, that is talking outta experience

hi asupan,
 can u plz give me its link, i m a bit confussed in Frsky modules

hi saikat
taping is not good solution and what about when I use it with simulator ? at that time I have to discon. tx module.

use Frsky DIY.. i am upgrading my aurora 9 system to frsky telemetry..

Are you sure that your module is loose in the Tx?? cross check it once again. i doubt if that can happen, as module is supported by two parallel locks on side other then the pin connection. if it is happening again and again, then i will suggest to bend the PINS very slightly towards the side walls of module socket and reinsert the module.

I am thinking of getting an aurora 9 to use with FRSKY. Is the radio as good as the reviews suggest. What Frsky module do you suggest. I was thinking of the one with the telemetry screen.
regards
Avijit
P.s. Request to the administrator: Could you split this off as a separate topic- "FRsky in aurora 9"

yes avjiy.. getting the telemetry screen DHT -U with ppm v+ and GND outputs.. u can directly plug it into aurora 9.. i have a 72 mhz aurora on which i will implement this.. i got another 2.4 auora as well.. but will soon be put on forum for sale once i get the telemetry kits.. frsky is far more reliable solution and better range for less mw of power. only 60mw. secondly the receivers are quite cheap compared to all the telemetry enabled 2 way combos..  i m sure it will be a proper hack to my aurora 9..
here is the link . u will get some idea
http://www.bambucopter.com/hitec-aurora-9-ppm-sum-with-frsky-dht-u/

rcpilotacro : Of course I'll but as a beginner I want to use Turnigy

paladugu_sujith : Can you please provide me HK link for Frsky DIY ?

Sandeepm : Yes module is loose, its both side clips are not working and when i insert module and shake radio it come out. I also put some paste on pins and then put some solder on it to make pin thick but still didnt work, I will try to bent is what else I can do ??

Search in tx rx systems. 2.4 frsky.