|
Title: Servos are jittering Post by: Adnan R.k on November 25, 2018, 11:45:02 PM I have flysky fs-ct6b/R6B tx/rx.
I connected a 4v battery directly on the rx and 3 servos. Whenever I operate any one servo rx light start blinking and all servos starts to jitter (vibrating with a considerable magnitude) for 20-30 secondes then stops.it happens every time. Title: Re: Servos are jittering Post by: prafulla on November 26, 2018, 12:22:18 PM Check with different ESC
Title: Re: Servos are jittering Post by: Balakrishna Reddy on November 26, 2018, 01:09:54 PM You may have answer here. http://www.rcindia.org/radios-and-receivers/what-is-current-capacity-of-flysky-receiver/msg295741/#new
Your receiver is rated for 5V. So if you connect a 4V battery it is low in the first place. Whenever you operate a servo it draws considerable amount of current which may lead to voltage sag in the battery i.e decrease in battery terminal voltage. If this terminal voltage is below the brownout voltage of receiver then receiver will just reboot or restart. remedy: 1. Since the receiver is rated for 5V+- 10~15% you can better plug a battery with that voltage. 2. Choose your battery such that it is capable of delivering required current for your application. This is the reason why many hobbyists choose liion or lipo. Title: Re: Servos are jittering Post by: Adnan R.k on November 26, 2018, 08:28:48 PM Thanks for your reply!
|