RC India

i'm having a weird issue here.. the receiver bids properly i.e. the receiver led stays on, but, there is no response on any of the receiver or the ESC, the servos all move to one of their ends. strangely enogh, the plush 60A esc does all the pre-initialization routines correctly neatly but it doesn't move the motor..
all the setup was tested working previously, this issue came out of nowhere.. :headscratch:
any ideas ??

Same problem here bro.... :'( :banghead:

Did you find any solution... ???

I have flysky 9ch tx rx

 make sure the TX battery voltage is sufficient at load.. make sure the main antenna is connected perfectly.. reset all values of the TX to factory default.. check the menu, and parameters of DR, ATV,EP etc, even after resting.. make sure the resting is executed and confirmed.. make sure the RX voltage is proper.. connect two servos to RX, and make sure all channels are working on the basis of default value.. then check for any software problem.. keep 1 meter distance at least, while pairing the radio set..  :thumbsup:

Chk the motor!

@reas check the battery and remove all load insert only one servo and test if all is working test one by one and ten connect motor and esc at last
 contact me i am in bbsr 8093863974

Hi guys , I had the same problem . The binding sequence is a bit different than what you must have done . Sai Krishna helped me out over the phone to bind the Rx .

Thank you guyz for your most generous answers...... :hatsoff:

Solved the problem!  {:)}