RC India

General Topics => RC General Topics => Topic started by: Sreedhar on June 19, 2010, 10:51:40 AM



Title: HAND LAUNCH
Post by: Sreedhar on June 19, 2010, 10:51:40 AM
Guys can u tell me what all things to keep in mind while performing a hand launch???


Title: Re: HAND LAUNCH
Post by: saikat on June 19, 2010, 11:19:44 AM
yes - most important - don't throw the tx and keep the plane


Title: Re: HAND LAUNCH
Post by: anwar on June 19, 2010, 11:28:30 AM
:giggle:  I think that is the most funny (yet "it makes sense" kinda) post till date on RC India ! ROFL


Title: Re: HAND LAUNCH
Post by: anwar on June 19, 2010, 11:31:53 AM
One big thing is to not aim it into the sky.  A 25degree to 40degree angle is more than enough.


Title: Re: HAND LAUNCH
Post by: Sreedhar on June 19, 2010, 12:13:29 PM
ha ha go go saikath  :giggle: :giggle: ( its really an important thing)..


Title: Re: HAND LAUNCH
Post by: sandeepm on June 19, 2010, 12:44:54 PM
One big thing is to not aim it into the sky.  A 25degree to 40degree angle is more than enough.
best point to take care....otherwise if you do a sky side throw your plane will stall and fall.....if thrust is not good......
next point, make sure that the motor is started before throw and not during throw.....


Title: Re: HAND LAUNCH
Post by: rajaram on June 19, 2010, 03:38:34 PM
what i have learn t from rajsigma and sandeep sir is to launch in direction of the wind
so that the model would not glide out (in the direction along with the wind)
regards
rajaram


Title: Re: HAND LAUNCH
Post by: anwar on June 19, 2010, 04:22:21 PM
That goes against conventional wisdom, and I have seen planes plunge into the ground when launched ALONG the wind (instead of AGAINST/INTO the wind).  Are you sure about this ?


Title: Re: HAND LAUNCH
Post by: sujju on June 19, 2010, 06:26:44 PM
yes - most important - don't throw the tx and keep the plane

LOL... good one...


Title: Re: HAND LAUNCH
Post by: rohitgupta322 on June 19, 2010, 08:49:04 PM
yes - most important - don't throw the tx and keep the plane
Haha this is the most hilarious post ive ever read. :giggle: ;D


Title: Re: HAND LAUNCH
Post by: bmanoj2 on June 19, 2010, 10:11:50 PM
I agree with Anwar. It has to be against the wind….
Make sure that your hands clear of servos, rx, servo horns, battery etc.
Try to give slight angle only.(20 to 30 deg)
Don’t use excessive force to launch
Release the model with soft hands.
Try to use a neck strap if you are holding Tx and launching all by yourself.(It also avoids the throwing of TX :giggle:)
Some models can are launched under arm and sideways (like throwing a Frisbee).

That goes against conventional wisdom, and I have seen planes plunge into the ground when launched ALONG the wind (instead of AGAINST/INTO the wind).  Are you sure about this ?


Title: Re: HAND LAUNCH
Post by: Dreamliner on June 20, 2010, 01:33:54 AM
Assuming that the model is high winger...........

Make sure that your model is properly balanced.
Hold the model at CG.
Model above your head level.
Nose pointing into the wind.
Wings parallel to ground.
Adequate power.
Run into the wind with model in hand raised above head.
Feel the model lifting.
Give it good throw and make sure wing level, nose slightly pointing downward when it leaves your hand so that model gains speed and it does not stall.
Follow what Saikat said above.
Elevator adquately up take rudder help at low heights to correct any veering from straight path.


Title: Re: HAND LAUNCH
Post by: anwar on June 20, 2010, 02:26:38 AM
The running and aiming level or ever slightly lower is only when you suspect (or if you are sure) that you do not have enough juice in the power system for the plane to take off comfortably, right ?  Otherwise standing still and aiming a bit upwards seems to work well in practice ?


Title: Re: HAND LAUNCH
Post by: bmanoj2 on June 20, 2010, 08:12:20 AM
The only model I throw running few steps is this Weston Magnum of my friend Mr. Lal. Its very heavy in construction because of the materials used to fabricate its strong body and belly area for landing in tarmac surface. This model doesn’t have a landing gear and reaches up to 150 mph + ??. The normal foamy planes are usually hand launched standing.


Title: Re: HAND LAUNCH
Post by: anwar on June 20, 2010, 10:38:33 PM
Wow ! What prompted the use of such a pipe ?  Screaming RPM, like in pylon racers ?

And what engine is that ?


Title: Re: HAND LAUNCH
Post by: bmanoj2 on June 21, 2010, 08:31:11 AM
I need to check with Mr. lal, I am not sure about the size too. ???


Title: Re: Hand Launching
Post by: prakkat on June 26, 2010, 09:40:02 AM
last week somebody was asking hand lounge this it. prakkat


Title: Re: Hand Launching
Post by: prakkat on June 26, 2010, 10:26:34 AM
according to ur mode u can use ur left or right hand,give 50 percent throttle and 60 percnt elevator and just push it.

Hand lounging, the person who stands near me is Issac Palat, he was a great flyer in 1950 s , he used to make his own designs in balsa. now eye problem hestops, but in this 80 s also very much interested, he comes me every time go for flying . and he is the uncle of aranthadi roy, author of GOD OF SMALL THINGS


Title: Re: HAND LAUNCH
Post by: santhosh on June 26, 2010, 10:20:35 PM
50 to 60 % is ok for twinstar but not for all models, what about launching a multiplex twister or funjet with half throttle ;) .it all depeds on the model and the power set up u r using


Title: Re: HAND LAUNCH
Post by: amulu10 on June 26, 2010, 10:30:28 PM
can someone tell how to throw a pusher prop like a funjet safely? i have read too many post where pusher prop planes have hurt the launcher!  :(


Title: Re: HAND LAUNCH
Post by: santhosh on June 26, 2010, 10:44:09 PM
sorry , i never hand launched a single one :giggle:


Title: Re: HAND LAUNCH
Post by: bmanoj2 on June 26, 2010, 10:58:54 PM
can someone tell how to throw a pusher prop like a funjet safely? i have read too many post where pusher prop planes have hurt the launcher!  :(
Best way is to swing and throw it, holding one side.(Like throwing a frizbee) Or under arm throw also is safe.


Title: Re: HAND LAUNCH
Post by: santhosh on June 26, 2010, 11:19:41 PM
from my experience (my friends are hand launching  all the time for me) give full throttle, this is what i usually what i do for my funjet, and throw a slightly upward angle to the sky


Title: Re: HAND LAUNCH
Post by: sanjayrai55 on April 16, 2018, 06:43:57 AM
(https://www.aeromodellers.co.uk/media/kunena/attachments/97/cartoon1.jpg)



Title: Re: HAND LAUNCH
Post by: manojswizera on April 16, 2018, 11:14:55 AM
 :rofl: