RC India
Welcome Guest, please login or register.
 
Pages: [1]   Go Down
0 Members and 1 Guest are viewing this topic. Topic Tools Topic Tools 
Read
« on: October 26, 2018, 06:32:07 PM »
Sashvat
Plane Lover
Active Member
**

Reputation Power: 1 
Sashvat has no influence.
Offline Offline

City: Chennai
State: Tamil Nadu
RC Skills: Intermediate
Posts: 2
Join Date: Oct, 2018




Hi guys, I am doing projects on drones and I was interested in Multiwii with an Arduino Nano (Atmega 328p). I followed all the instructions from- http://www.electronoobs.com/eng_robotica_tut5_3.php

My drone is arming and motors run, but as I increase the throttle the drone just stays on the ground and doesn't fly. Can anyone tell me what I should do?

Thank you
Logged
 

Read
« Reply #1 on: October 26, 2018, 11:03:49 PM »
Balakrishna Reddy
Plane Lover
Forum Hero
*****

Reputation Power: 7 
Balakrishna Reddy has no influence.
Offline Offline

City: Hyderabad
State: Telangana
RC Skills: Intermediate
Posts: 603
Join Date: Feb, 2015



Can you try to elaborate a little.
How did u arm the flight controller? Did u assign any switch or throttle down yaw max?
Did you check in the configurator if multiwii is able to capture the inputs or not?
Does motor speed increase when u throttle up atleast by some percent?
Before you proceed to any test I strongly suggest to remove propeller to avoid surprising ramming.
Logged
 

Read
« Reply #2 on: November 14, 2018, 07:36:47 AM »
Sashvat
Plane Lover
Active Member
**

Reputation Power: 1 
Sashvat has no influence.
Offline Offline

City: Chennai
State: Tamil Nadu
RC Skills: Intermediate
Posts: 2
Join Date: Oct, 2018



Yes I have set throttle down, yaw max for arming and disarming. I have checked in the configurator for the inputs all the inputs seem fine. The motors speed increase as the throttle increases, but when I fly it, it doesn't lift off the ground. The motors are not giving enough power to life the drone off the ground.
Logged
 

Pages: [1]   Go Up
Jump to: