I had an IDEA to Build A gimbal using flight stabilizing gyro .....SO here is what I did
Items needes
1 2* 9g servos
2 thunjer p1 gyro
3 few plastic pieces for Camera mount
It was simple like every other gimbal build
It works perfect it stabilizes the Camera ...
What is did was I used gyro ON headlock mode
I used elev and aile outputs of gyro as 2 Axis for stabilizing
But ON the input side I Just connected aile input to receiver and a swithch wire ON channel 8 of receiver ....to put gyro ON headlock mode ... aile input is conmected ON channel 5 .....it was necessary because that wire powers the gyr
Rest of input signals of gyro are left alone
And two ouput used for gimbal
I works perfect
But here is the problem I am facing everytime I push or titl the gyro out of servos limit of responce to rotation ...when I move back to normal position I lose the Centre position of servo ....if I go out of limit Service centres in a different position ....
But till that extreme position is not somthing a quad CAN do if I angle my gyro more then 35-40 degree Om any of the 2 Axis I loss Centre position of Service
What should I do
CAN I use a different servo which won't lose its Centre posotion in any extreme please give some advice
Print
