Title: ESC Conversion; Brushless to Brushed Post by: Voice of deaf on September 13, 2018, 02:58:13 AM Hi,
While surfing around, I found something useful. There is a guyhttps://www.instagram.com/arnabdasbwn (https://www.instagram.com/arnabdasbwn) who makes stuff and I somehow stumbled upon his bloghttp://www.arnabkumardas.com (http://www.arnabkumardas.com) and found out a possible solution to the Brushed ESC requirement. (https://upload.wikimedia.org/wikipedia/commons/thumb/5/58/Halfwave.rectifier.en.svg/770px-Halfwave.rectifier.en.svg.png) (https://upload.wikimedia.org/wikipedia/commons/thumb/d/d5/Gratz.rectifier.en.svg/765px-Gratz.rectifier.en.svg.png) (https://upload.wikimedia.org/wikipedia/commons/thumb/5/5c/Fullwave.rectifier.en.svg/760px-Fullwave.rectifier.en.svg.png) http://www.arnabkumardas.com/blog/diy-project/3-phase-rectifier-for-esc (http://www.arnabkumardas.com/blog/diy-project/3-phase-rectifier-for-esc) is his web address of that post. I sincerely hope this will solve the many people's requirement of a brushed ESC to an extent, (including my own ;)) I do not take responsibility for any blown ESC, as neither the design nor the Blog is mine. Though I recommend trying it ;) Regards :hatsoff: Title: Re: ESC Conversion; Brushless to Brushed Post by: prabal276 on September 13, 2018, 10:45:13 AM It makes a lot of sense!
I was going to get brushed esc's for my Mars Rover but i will give this a try with an old ESC first. I do have some doubts though.... Thanks for sharing. Title: Re: ESC Conversion; Brushless to Brushed Post by: Voice of deaf on November 17, 2018, 11:18:45 PM It makes a lot of sense! Totally interested (guess others too are) in your Mars Rover 🎮🕹. (think i heard that somewhere on HobbyKing's Brushed ESC's Reviews where a guy drove 3 motors with one ESC on each side of his rover.I was going to get brushed esc's for my Mars Rover but i will give this a try with an old ESC first. I do have some doubts though.... Thanks for sharing. And so post your doubts, I if not somebody else will surely on it. 👍 Title: Re: ESC Conversion; Brushless to Brushed Post by: saikat on November 18, 2018, 12:09:01 AM This is a roundabout solution .
If you want to convert a brushless esc to brushed then reprogram the micro controller Easy and simple https://www.rcgroups.com/forums/showthread.php?1649270-Reprogram-a-brushless-ESC-to-get-a-brushed-ESC-with-no-delays-RC-Switch I have tried it and it works 100 % |