Title: HK QuadRotor Board Post by: ram singh on February 23, 2012, 02:30:32 PM Hello all friends, please help me.
My HK quad-rotor control board gyros are not working but throttle are working OK. But cannot found any effect on motors speed, after increase/decrease gyro trimmer or tilting the quad-rotor frame. Sorry, my English is poor & sorry for any wrong write. Title: Re: HK QUADROTOR BOARD Post by: anwar on February 24, 2012, 12:27:05 AM Note that the effect will be visible only at some amount of throttle. If you just tilt it at zero or very low throttle, nothing will happen. You will need a certain amount of throttle before you can notice the gyro action.
Also, please make sure you follow the setup procedure properly/exactly. Title: Re: HK QUADROTOR BOARD Post by: AyushGupta on February 24, 2012, 12:31:58 AM Also while powering up ensure the gain potentiometers are in middle position as the extreme during startup make the code enter in settings mode...
Please follow these instructions... http://www.kkmulticopter.kr/index.html?modea=manual (http://www.kkmulticopter.kr/index.html?modea=manual) Hope this helps..... Just my 2 cents :) Title: Re: HK QuadRotor Board Post by: ram singh on February 24, 2012, 01:25:46 PM thank you anwar sir and ayus gupta I process............
|