Title: Making a fixed wing out of toy parts Post by: THE RC GUY on June 18, 2020, 07:03:22 PM hello group members
i am trying to make a fixed wing plane from parts salvaged from a wall climbing toy,the electronics are quite heavy and the system is based on IR so the range is also not good,it is a 2 channel rx tx ,will use two dual motor setup for yaw and pitch.my past designs showed very bad flight characteristics and i never achieved desired results any specific design recommendations?,if yes then please share :help: regards Nitya Title: Re: Making a fixed wing out of toy parts Post by: Bilal on June 19, 2020, 04:54:52 PM Hi, check out this build thread, similar electronics, similar setup, excellent flyer
http://www.rcindia.org/electric-planes/plan-build-hangar-rat-(build-log)/ |